Editing RB30 Installing Extractors

[[category:Engine]]
[[category:RB30E]]


==How to install RB30E Extractors==

All of the photos can be clicked for bigger images.




==Tools==

'''#1'''

These are the tools required - socket set, extension, offset ring spanners, and a big hammer:

[[Image:Step_1.jpg|600px]]



==Heatshield Off Manifold==

'''#2'''

Using the Socket Spanner and a 6mm bit and a Extension bar or Screwdriver remove the screws/bolts on the Heatshield:

[[Image:Step_2.jpg|600px]]



==Manifold Off Head==

'''#3'''

Some of the nuts are shrouded very closely by the manifold casting, so you'll need the thinnest wall socket you've got. Unbolt the manifold nuts:

[[Image:Step_3.jpg|600px]]

'''#4'''

[[Image:Step_4.jpg|600px]]

'''#5'''

Slip the manifold back off the studs:

[[Image:Step_5.jpg|600px]]



==Flange Off Cat==

'''#6'''

Unbolt the flange from the cat:

[[Image:Step_6.jpg|600px]]

'''#7'''

Drop the flange:

[[Image:Step_7.jpg|600px]]

'''#8'''

Another view:

[[Image:Step_8.jpg|600px]]


==More Removal==

'''#9'''

Remove the exhaust manifold:

[[Image:Step_9.jpg|600px]]

'''#10'''

Remove the gasket:

[[Image:Step_10.jpg|600px]]

'''#11'''

Exhaust manifold removed:

[[Image:Step_11.jpg|600px]]

'''#12'''

Remove the oxygen sensor:

[[Image:Step_12.jpg|600px]]



==New Extractors On==

'''#13'''

Comparison of the manifold with the extractors:

[[Image:Step_13.jpg|600px]]

'''#14'''

New extractors sitting in place, with new gasket:

[[Image:Step_14.jpg|600px]]

'''#15'''

Bolt the extractors onto the head.  Notice the oxygen sensor is now hooked up on one of the branches:

[[Image:Step_15.jpg|600px]]

'''#16'''

Bolt the new flange onto the cat:

[[Image:Step_16.jpg|600px]]